Mobile site
Scanll QR code
Copyright CHINA SINOTRUK INTERNATIONAL CO., LIMITED. All rights reserved ICP88888
18802226543
HOTLINE:
.
Single stage Hydraulic Cylinder
Characteristic
The hydraulic cylinder is made of seamless steel tube
The cast iron piston and sealing employ ZTM03-2-220 guide tape and UN200YX shaped ring
The cylinder head is bolted to the cylinder blockthe piston rod and cylinder head are equipped with SNY seal ring and SCK dust ring
The carrying shaft and cylinder bottom are welded into one piece and the oil inlet is arranged at the middle of the carrying shaft
With the built-in limit valuewhen the compartment is lifted to the maximum angle the oil in the hydraulic cylinder lower chamber will pass this value and flow back to the tank to stop lifting
The hydraulic cylinder bottom is provided with cushioning devicewhich will generate the throtting action immediately before the compartment is lowered to the end to slow down the compartment lowering and reduce the impact to the sub-frame
The cylinder is not provided with oil tankwhich should be individually supplied
The lifting cylinder top head is equipped with oil fillerthrough which and the tank filler the oil can be filled to the closed loop system.
Application scope
1.T type lifting machanism cylinder are suitable for tippers with the compartment length within 4200-6300mmcarrying capacity within 25t-45t.
2.F type lifting machanism cylinder are suitable for tippers with the compartment length within 4800-5600mmcarrying capacity within 25t-40t.